Scopul acestui studiu este cercetarea tensiunilor şi
deformaţiilor într-o epruvetă din material compozit utilizat în construcţia palelor pentru turbine eoliene. Partea experimentală a studiului constă din fabricarea unor epruvete din poliester armat cu fibre de sticlă (Eglass) prin metoda de Formare prin Transfer de Răşină în Vid Asistat. Apoi, pentru a determina unele proprietăţi mecanice ale materialului obţinut acesta a fost testat la întindere. Simularea computaţională a fost efectuat în programul de analiză cu elemente finite ANSYS.
Epruveta a fost modelată conform datelor experimentale.
Rezultatele experimentale şi numerice au fost comparate.
The purpose of this study is to investigate stresses and
strain in specimen of composite material used in wind
turbine blade construction. In this experimental study,
Polyester/ E-Glass composite plate was manufactured by
Vacuum Assisted Resin Transfer Molding. Then, in order
to determine a few mechanical properties of the composite specimen, tensile tests were made. Numerical study was performed by using finite element analysis software ANSYS. The test specimens were modeled in accordance to experimentally tested specimens. The results of the numerical and experimental studies were compared.
L'objectif de cette étude est d'examiner les contraintes et déformations dans des échantillons de matériau composite utilisé dans la construction de pales d'éoliennes. Dans cette étude expérimentale, verre E/ polyester composite plaque a été
fabriqué par moulage par transfert de résine sous vide
assistée. Puis, dans le but de déterminer les propriétés
mécaniques de l'échantillon composite ont été effectués
tests de traction. Étude numérique a été réalisée à l'aide
logiciel FEM (analyse par éléments finis) ANSYS. Les
éprouvettes ont été modélisées en fonction de spécimens
testés expérimentalement. Les résultats des études
numériques et expérimentales ont été comparés.
Целью данного исследования является изучение напряжений и
деформаций в образцах из композитного материала,
использованного в конструкции лопастей ветряной турбины. В этом экспериментальном исследовании, была изготовлена пластина из полиэстер/E-Glass методом VARTM. Потом, для того, чтобы
определить некоторые механические свойства композитного образца, были сделаны испытания на растяжение. Численное исследование проводилось с использованием анализа методом конечных элементов в программе ANSYS. Испытуемые
образцы были смоделированы в соответствии с экспериментальными. Результаты численного и
экспериментального исследования были сопоставлены.
|